The Shell. Yes it looks in a bad way, however the only rot is in the four
corners which is not actually that bad.
Floors have been replaced on both sides, also some bulkhead work has been done.
Nearside corner
Off side. Bad quality welding so this will be taken off and a new panel put in
Near side quarter and bottom edge of floor. Again this will be cut out .
Near side rear corner all cut out and ready for a new panel
70% through the engine rebuild. This was a mess but now looks factory fresh
Black powder coated tin ware will grace the engine bay ... None of that Chrome tat !!
Nice a clean ........just how we like it.
No comments:
Post a Comment